How to Install Heart Button and Thumb Grip Caps on Switch

Quick answer

Installing GeekShare Heart Button and Thumb Grip Caps takes about two minutes. Align the thumb grip cap with the analog stick, press down evenly, then gently stretch the button caps over the Joy-Con face buttons.

Step-by-step installation guide

1. Step 1: Clean your Joy-Con: Wipe the analog sticks and face buttons with a dry, lint-free cloth to remove dust or oil. This helps the silicone caps grip better and prevents slipping. A clean surface reduces the chance of the caps sliding off during gameplay.
2. Step 2: Install the thumb grip caps: Hold the thumb grip cap by its edges and center it over the analog stick. Press down firmly from the top center until you feel it snap into place around the stick's rim. Do not pull on the sides—push from the center. Common mistake: pulling the cap sideways can tear the silicone. Always press straight down.
3. Step 3: Install the heart button caps: Pick up one heart-shaped button cap and align it with the corresponding Joy-Con button (A, B, X, or Y). Gently stretch the cap's opening over the button, starting from one edge and working your way around. Avoid overstretching—the cap should fit snugly without force. If the cap feels too tight, try rotating it slightly to find the easiest angle. Never use tools or teeth.
4. Step 4: Check for secure fit: Press each button a few times to make sure the cap does not shift or pop off. The caps should move with the button without sticking or rattling. If a cap feels loose, remove it and reinstall, making sure it is fully seated. A loose cap can interfere with button responsiveness. Re-seat it immediately.
5. Step 5: Test all controls: Turn on your Switch and navigate through menus, press each button, and move the analog sticks in all directions. Confirm that the caps do not catch on the Joy-Con shell or each other. If a cap rubs against the shell, it may not be aligned properly. Remove and reinstall with more care.

What you are installing

• GeekShare Heart Button and Thumb Grip Caps: Cute Heart Button Design – Add a playful decorative touch to your Nintendo Switch Joy-Con while making the controls more eye-catching. The heart-shaped button caps are designed to fit over the existing buttons, so you get a custom look without permanent modification.

  

• GeekShare Heart Button and Thumb Grip Caps: Soft Silicone Feel – Made of non-toxic, odorless silicone for a soft and comfortable touch while helping protect the analog sticks from scratches and dirt. The silicone material grips the stick and buttons securely, but you need to install them carefully to avoid tearing the thin edges.